From: "Mithat Gonen" <mgonen@my-deja.com>
Subject: NONMEM error msg
Date: Thu, 16 Aug 2001 13:14:30 -0700
Hi everyone,
we have a NONMEM error msg- "tot no. of pred-defined recs in buffer 6 is less than no. of data recs with some individual". We have NONMEM running under Windows 2000 OP system.
Can someone please shade some light on what is causing this?
Mithat
NONMEM error msg
From: "Sam Liao" <sliao@pharmaxresearch.com>
Subject: Re: NONMEM error msg
Date: Thu, 16 Aug 2001 20:59:34 -0400
Dear Mithat:
The fix to this problem can be found on page 28 of the Installation guide,
section 2.9.4.
you can take the following steps to fix the buffer 6 problem:
1) edit the file "nsizes" in c:\nmv\nm folder, change LIM6=200 to LIM6=400
or higher depending on the max no of rec of each patient in your NONMEM data
2) recompile the DAT6.for subroutine; in a DOS prompt where you were
running the NONMEM job
and enter the command "df /c /optimize:1 /fpe:0 c:\nmv\nm\DAT6.for".
3) move the DAT6.obj file from the current dir to c:\nmv\nm
4) rebuild the binary library; enter the command "link /lib /out:nonmem.lib
c:\nmv\nm\*.obj"
5) move the nonmem.lib file from the current dir to c:\nmv\nm
6) run the NONMEM job again, increase more in LIM6 if the same problem
persist.
For similar problem in buffer 1-7 and 11, you can fix it the same way.
Best regards,
Sam Liao, Ph.D.
PharMax Research
270 Kerry Lane,
Blue Bell, PA 19422
phone: 215-6541151
efax: 1-720-2946783