Re: NONMEM error msg

From: "Sam Liao" <sliao@pharmaxresearch.com> Subject: Re: NONMEM error msg Date: Thu, 16 Aug 2001 20:59:34 -0400 Dear Mithat: The fix to this problem can be found on page 28 of the Installation guide, section 2.9.4. you can take the following steps to fix the buffer 6 problem: 1) edit the file "nsizes" in c:\nmv\nm folder, change LIM6=200 to LIM6=400 or higher depending on the max no of rec of each patient in your NONMEM data 2) recompile the DAT6.for subroutine; in a DOS prompt where you were running the NONMEM job and enter the command "df /c /optimize:1 /fpe:0 c:\nmv\nm\DAT6.for". 3) move the DAT6.obj file from the current dir to c:\nmv\nm 4) rebuild the binary library; enter the command "link /lib /out:nonmem.lib c:\nmv\nm\*.obj" 5) move the nonmem.lib file from the current dir to c:\nmv\nm 6) run the NONMEM job again, increase more in LIM6 if the same problem persist. For similar problem in buffer 1-7 and 11, you can fix it the same way. Best regards, Sam Liao, Ph.D. PharMax Research 270 Kerry Lane, Blue Bell, PA 19422 phone: 215-6541151 efax: 1-720-2946783