Re: $SIZES failed
Hi,
Sam is using WFN.
WFN adds -prdefault by default to the command line. This speeds up typical use of NONMEM by avoiding recompilation. The default behaviour is changed by unsetting the environment variable args7:
set args7=
This will then allow WFN users to use $SIZES.
Best wishes,
Nick
Quoted reply history
On 18/06/2015 12:42 a.m., Sam Liao wrote:
> Dear Robert,
> I did not have –prdefault anywhere in my command.
>
> Best regards,
> Sam Liao
> Pharmax Research Inc.
> 14 Upland,
> Irvine, CA 92602
> Phone: 201-9882043
> efax: 720-2946783
> www.pharmaxresearch.com
>
> On 6/17/2015 2:21 PM, Bauer, Robert wrote:
>
> > Do not add –prdefault on your command line.
> >
> > Robert J. Bauer, Ph.D.
> >
> > Vice President, Pharmacometrics R&D
> >
> > ICON Early Phase
> >
> > Office: (215) 616-6428
> >
> > Mobile: (925) 286-0769
> >
> > [email protected] <mailto:[email protected]>
> >
> > www.iconplc.com http://www.iconplc.com
> >
> > *From:* [email protected] [ mailto: [email protected] ] *On Behalf Of *Sam Liao
> >
> > *Sent:* Wednesday, June 17, 2015 1:36 PM
> > *To:* [email protected]
> > *Subject:* [NMusers] $SIZES failed
> >
> > Hi,
> > My PK model has 42 theta and 35 omega exceeding the default limits.
> > When I used $SIZE to change these size in my control file, I still get
> > the error msg from nmtran.exe
> > "MAY NOT USE -prdefault: LVR IN SIZES.f90 WOULD NEED TO BE INCREASED
> > TO 35"
> >
> > Is there way to get around this problem? Somehow, the $SIZE statement in
> > the control stream was ignored.
> >
> > --
> > Sam Liao
> > Pharmax Research Inc.
> > 14 Upland,
> > Irvine, CA 92602
> > Phone: 201-9882043
> > efax: 720-2946783
> > www.pharmaxresearch.com http://www.pharmaxresearch.com
> >
> >