RE: dos() function in s-plus to call NONMEM using the bootstrappeddata
Lu,
You can Copy nmfe5.bat to the project SPLUS project folder. This is a
good practice, I copy the nmfe5.bat, the control stream and data files
into a project folder. I use that folder as my SPLUS folder. This way,
you can run your NonMem using the dos() command in SPLUS without having
to specify a folder, and you'll have all input and output files in one
place.
Malaz
Malaz A. AbuTarif,
B.Sc. (Pharmacy), Ph.D., G.C.P.M., M.B.A.
Principal Scientist, Schering- Plough Research Institute
2015 Galloping Hill Rd, K-15-2-2650
Kenilworth, NJ 07033
Tel: (908) 740-3835, Fax: (908) 740-2916
[EMAIL PROTECTED]
Quoted reply history
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
On Behalf Of Zheng Lu
Sent: Tuesday, April 24, 2007 5:20 PM
To: nmusers
Subject: [NMusers] dos() function in s-plus to call NONMEM using the
bootstrappeddata
Dear All:
Could someone tell how to use dos() in S-plus to run NONMEM for
Bootstrapped Data. In my computer, NONMEM can be run in standard DOS
window, my basic question is how to specify the path of .ctl file and
.lst file, when I write dos('nmfe6 amiwr.ctl amiwr.lst')in s-plus, the
message of no amiwr.ctl found was returned, even amiwr.ctl is already
under c:\, thank you very much for your consideration and help.
Zheng
*********************************************************************
This message and any attachments are solely for the
intended recipient. If you are not the intended recipient,
disclosure, copying, use or distribution of the information
included in this message is prohibited -- Please
immediately and permanently delete.